Differences

This shows you the differences between two versions of the page.

--- 3d_print_wx_station [2023/09/09 21:26] – [Telnet connect] ok1hra
+++ 3d_print_wx_station [2023/09/14 11:31] (current) – ok1hra
@@ Line 1: / Line 1: @@
-====== 3D print WX station (release 2023) ======
+====== 3D print APRS WX station (release 2023) ======
 {{ https://remoteqth.com/img/wiki-wx-station2-78.jpg?300}}
 Ethernet PoE weather station
@@ Line 175: / Line 175: @@
 -90     B68NpG7F0t
 -100    5mD04pAE6s</code>
-  * if you **enter wrong three times,** login will be **blocked for next ten minutes**
+  * if you **enter wrong three times,** login will be **blocked for next ten minutes** (It can be worked around by resetting the power supply to the weather station).
-  * After login your IP address store to EEPROM and next key will be required **only if change your IP** address
+  * After login your IP address will be stored in the EEPROM and next key not will be required **only if change your IP** address
-  * Now logged in to CLI (command line interface) via telnet \\ {{https://remoteqth.com/img/wiki-wx-station2-telnet.png?400}}
+  * Now logged in to CLI (Command Line Interface) via telnet \\ {{https://remoteqth.com/img/wiki-wx-station2-telnet.png?400}}
   * for **Logout** press **q** \\
@@ Line 210: / Line 210: @@
 If you enter the IP address of your weather station in the web browser, it will be displayed
-  - **MQTT wall** - client that displays measured values every 5 minutes \\ {{https://remoteqth.com/img/wiki-wx-station2-mqtt.png?150}}
+  - **MQTT wall** - client connected to MQTT broker that displays received values every 5 minutes \\ {{https://remoteqth.com/img/wiki-wx-station2-mqtt.png?150}}
   - The page header displays basic information and important links
     - **APRS** (if active) - link to the APRS map, where you can view the annual history of values, link to view the WX chart \\ {{https://remoteqth.com/img/wiki-wx-station2-aprs.png?150}}
@@ Line 246: / Line 246: @@
     - DallasTemperature, rev 3.9.0
     - the current list can be found in {{https://github.com/ok1hra/3D-print-WX-station/blob/master/wx.ino#L78|source code}}
-  - Download firmware from [[https://github.com/ok1hra/3D-print-WX-station|GitGub]]
+  - Download firmware from [[https://github.com/ok1hra/3D-print-WX-station|GitHub]]
   - Select menu Tools/Board:"OLIMEX ESP32-POE"
   - Connect