Differences

This shows you the differences between two versions of the page.

--- din-wifi [2025/12/03 17:36] – ok1hra
+++ din-wifi [2025/12/05 09:51] (current) – [Main features] ok1hra
@@ Line 11: / Line 11: @@
   * **Three** open collector **outputs**
   * Mounting on **DIN rail**
+  * Not expandable
   * **ESPhome** firmware \\ \\
-  * Block diagram \\ {{https://remoteqth.com/img/din-module-wifi-blok.png?600}}
+  * Block diagram \\ \\ {{https://remoteqth.com/img/din-module-wifi-blok.png?600}} \\ \\ \\ {{https://remoteqth.com/img/wiki-din-module-w-28.jpg?600}}
 ----
@@ Line 20: / Line 21: @@
   - On your PC/notebook/phone select **WiFi AP "EMS NG"** and connect it
   - **Password is "12345678"**
-  - open url **[[http://192.168.4.1|http://192.168.4.1]]** and select your home WiFi AP and connect it
+  - open url **[[http://192.168.4.1|http://192.168.4.1]]** and select your home WiFi AP and Save \\ {{https://remoteqth.com/img/wiki-din-module-w-33.png?300}}
-  - After rebooting, connect a serial console (115200 baud) where you will see a connection to your home AP and an **IP address assigned from DHCP**. After connecting to this address, you can configure the device via the web interface...
+  - After rebooting, connect a serial console (115200 baud) to USB-C where you will see a connection to your home AP and an **IP address assigned from DHCP**. \\ {{https://remoteqth.com/img/wiki-din-module-w-34.png?300}}
+  - After connecting to this address, you can configure the device via the web interface. \\ {{https://remoteqth.com/img/wiki-din-module-w-35.png?300}}
   - Asociate to Home assistant...
@@ Line 28: / Line 30: @@
 ====== Update firmware ======
 **Precompiled firmware** in .bin format
-  - is available on [[https://github.com/ok1hra/eth-din-dev-kit/releases|GitHub release]] page (with **ESPhome** label) in two variants. With activated WiFi or Ethernet interface - choose variant according to the interface you want to use.
+  - is available on [[https://github.com/ok1hra/eth-din-dev-kit/releases|GitHub release]] page (with **ESPhome** label only) in two variants. With activated WiFi or Ethernet interface - choose variant according to the interface you want to use.
   - you can compile your own .bin file according to the configuration .yaml file also available on [[https://github.com/ok1hra/eth-din-dev-kit/blob/main/esphome-solarbeam-version-linear-regulation.yaml|GitHub]]
 **You can upload the firmware in two ways**
-  - via the web interface of your own device (integrated in ESPhome) \\ {{https://remoteqth.com/img/wiki-din-module-w-31.png?350}}
+  - via the web interface of your own device (integrated in ESPhome) \\ In AP mode \\ {{https://remoteqth.com/img/wiki-din-module-w-31.png?300}} \\ or \\ {{https://remoteqth.com/img/wiki-din-module-w-35.png?300}}
   - via USB-C using, for example, the web tool https://web.esphome.io/