simple_rotator_interface_v
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| simple_rotator_interface_v [2026/09/27 09:18] – [DC motor with PWM, without hardware endstop (safe mode)] ok1hra | simple_rotator_interface_v [2026/09/27 09:19] (current) – [DC motor without PWM] ok1hra | ||
|---|---|---|---|
| Line 262: | Line 262: | ||
| - Don't forget to **bridge or replace the diode D24 with a jumper.** | - Don't forget to **bridge or replace the diode D24 with a jumper.** | ||
| - Make the **jumper with a copper wire** with a cross-section of 1.5 mm< | - Make the **jumper with a copper wire** with a cross-section of 1.5 mm< | ||
| + | |||
| + | | **Setup** Web page basic settings - [[# | ||
| + | | Hardware endstops | //depending on the rotator used// | | ||
| + | | Motor supply | **DC** | | ||
| + | | DC PWM control | **OFF** | | ||
| + | |||
| ---- | ---- | ||
simple_rotator_interface_v.txt · Last modified: by ok1hra