Differences

This shows you the differences between two versions of the page.

--- simple_rotator_interface_v [2026/09/27 09:12] – [AC motor] ok1hra
+++ simple_rotator_interface_v [2026/09/27 09:19] (current) – [DC motor without PWM] ok1hra
@@ Line 230: / Line 230: @@
     * Observe the **maximum prescribed loading.**
     * We recommend using the **following safe option with software endstops.**
+| **Setup** Web page basic settings - [[#setup_web_page|more]]  |
+| Hardware endstops | //depending on the rotator used// |
+| Motor supply | **DC** |
+| DC PWM control | **ON** |
 ----
@@ Line 240: / Line 245: @@
     * observe the **polarity of the power supply,** otherwise the power mosfet may be destroyed. \\
     * observe the **maximum prescribed loading.**
+| **Setup** Web page basic settings - [[#setup_web_page|more]]  |
+| Hardware endstops | **NOT INSTALLED** |
+| Motor supply | **DC** |
+| DC PWM control | **ON** |
@@ Line 252: / Line 262: @@
     - Don't forget to **bridge or replace the diode D24 with a jumper.**
     - Make the **jumper with a copper wire** with a cross-section of 1.5 mm<sup>2</sup> \\ {{https://remoteqth.com/img/wiki-simple-rot-67.jpg?400}}
+| **Setup** Web page basic settings - [[#setup_web_page|more]]  |
+| Hardware endstops | //depending on the rotator used// |
+| Motor supply | **DC** |
+| DC PWM control | **OFF** |
 ----