Differences

This shows you the differences between two versions of the page.

--- simple_rotator_interface_v_kit [2024/12/16 19:38] – [Assembly optional front panel] ok1hra
+++ simple_rotator_interface_v_kit [2024/12/16 19:40] (current) – [Assembly optional front panel] ok1hra
@@ Line 137: / Line 137: @@
   - Check the presence of all necessary components \\ {{https://remoteqth.com/img/wiki-simple-rot-44.jpg?250}}
-  - Solder the connection cable to the potentiometer. **Attention, it is necessary to observe the positions of the colors of the wires** \\ {{https://remoteqth.com/img/wiki-simple-rot-74.png}} {{https://remoteqth.com/img/wiki-simple-rot-45.jpg?250}}
+  - Solder the connection cable to the potentiometer. **Attention, it is necessary to observe the positions of the colors of the wires** \\ {{https://remoteqth.com/img/wiki-simple-rot-74.png?400}} \\ {{https://remoteqth.com/img/wiki-simple-rot-45.jpg?250}}
   - Glue the four rubber feet to the underside of the 3D printed model as shown \\ {{https://remoteqth.com/img/wiki-simple-rot-46.jpg?250}}
   - Force push/punch the plug in the center of the front of the 3D printed box \\ {{https://remoteqth.com/img/wiki-simple-rot-47.jpg?250}}