3d_print_wx_station
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
3d_print_wx_station [2021/03/18 06:49] – [Firmware upload] ok1hra | 3d_print_wx_station [2021/03/18 06:50] – [Firmware upload] ok1hra | ||
---|---|---|---|
Line 80: | Line 80: | ||
- After firmware upload you can upload next version of the firmware via IP, if you computer in same network. In Arduino IDE shows another choice Network ports \\ {{https:// | - After firmware upload you can upload next version of the firmware via IP, if you computer in same network. In Arduino IDE shows another choice Network ports \\ {{https:// | ||
- password for OTA upload is // | - password for OTA upload is // | ||
- | - After first upload also available upload binary via web \\ {{https:// | + | - After first upload also available upload binary via web \\ {{https:// |
---- | ---- |
3d_print_wx_station.txt · Last modified: 2023/09/14 11:31 by ok1hra