3d_print_wx_station
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| 3d_print_wx_station [2021/03/18 06:50] – [Firmware upload] ok1hra | 3d_print_wx_station [2021/04/08 04:57] – [How to build] ok1hra | ||
|---|---|---|---|
| Line 177: | Line 177: | ||
| - With press the pliers to put on{{https:// | - With press the pliers to put on{{https:// | ||
| - Screw in M3x10 to printed **parts number 14**{{https:// | - Screw in M3x10 to printed **parts number 14**{{https:// | ||
| - | - fit the azimuth blade and screw it on stainless steel threaded rod M6x125mm on, **so as to keep them horizontally balanced** - M6 nuts can be screwed in for balancing{{https:// | + | - fit the azimuth blade and screw it on stainless steel threaded rod M6x125mm on, **so as to keep them horizontally balanced** - M6 nuts can be screwed in for balancing{{https:// |
| - Fit part number 14 on part number 12 so that the locking **screw is against the bottom hole**{{https:// | - Fit part number 14 on part number 12 so that the locking **screw is against the bottom hole**{{https:// | ||
| - Install the three anemometer blades{{https:// | - Install the three anemometer blades{{https:// | ||
3d_print_wx_station.txt · Last modified: 2023/09/14 11:31 by ok1hra