ci-v_mqtt_stepper
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ci-v_mqtt_stepper [2020/11/13 15:14] – [Quick start guide] ok1hra | ci-v_mqtt_stepper [2022/01/04 17:22] – [Firmware] ok1hra | ||
---|---|---|---|
Line 13: | Line 13: | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
+ | === Known issue === | ||
+ | - Q1 - bad footprint pinout | ||
====== Connect ====== | ====== Connect ====== | ||
===== Endstop ===== | ===== Endstop ===== | ||
Line 68: | Line 69: | ||
* after first boot login to serial console with default login **pi** and password **raspberry** | * after first boot login to serial console with default login **pi** and password **raspberry** | ||
* run command and **enable [[https:// | * run command and **enable [[https:// | ||
- | * run command and write down the shown ''' | + | * run command and write down the shown **IP address** < |
* you can disconnect HDMI monitor and USB keyboard | * you can disconnect HDMI monitor and USB keyboard | ||
* connect to Raspberry PI from any other PC | * connect to Raspberry PI from any other PC | ||
- | * [windows|https:// | + | * [[https:// |
- | * [Linux|https:// | + | * [[https:// |
- | * [iOS|https:// | + | * [[https:// |
- | * update system with run command{{sudo apt-get update && sudo apt-get upgrade}} | + | * update system with run command |
- | * install screen fith command | + | * install screen fith command |
- | * run ''' | + | * run **screen** < |
- | * now after pres ? key show status information and you can ''' | + | * now after pres **?** key show status information and you can **configure via CLI** \\{{https:// |
- | * close screen with ''' | + | * close screen with **CTRL+A K** and confirm |
- | * disconnect from Raspberry PI use command | + | * disconnect from Raspberry PI use command |
- | !Firmware | + | ==== Firmware |
- | For upload firmware you have two possibilities | + | For upload firmware you have two possibilities |
- | # Download ''' | + | - Ordered List ItemDownload **source** from [[https:// |
- | ## Install [EEPROM library|https:// | + | |
- | # Download | + | |
- | ## for example [avrdude|http:// | + | |
- | !! Firmware source | + | ==== Firmware source |
- | contains some settings which does not available from CLI | + | contains some settings which does not available from CLI \\ |
* You can enter ''' | * You can enter ''' | ||
**Disable preset coment line{{//# | **Disable preset coment line{{//# | ||
Line 109: | Line 110: | ||
* CLI baudrate, default is 115200{{const int BAUDRATE0 = 115200;}} | * CLI baudrate, default is 115200{{const int BAUDRATE0 = 115200;}} | ||
- | !MQTT variant | + | ==== MQTT variant |
- | * need install wiznet ethernet module | + | * need install wiznet ethernet module |
- | * use another firmware [GitHub|https:// | + | * use another firmware [GitHub|https:// |
- | * for setup and control see source code header | + | * for setup and control see source code header |
ci-v_mqtt_stepper.txt · Last modified: 2022/01/04 17:29 by ok1hra