Differences

This shows you the differences between two versions of the page.

--- ethernet_splitter_poe [2020/10/30 20:32] – created ok1hra
+++ ethernet_splitter_poe [2020/10/31 08:42] (current) – [Ethernet splitter +POE] ok1hra
@@ Line 1: / Line 1: @@
+====== Ethernet splitter +POE ======
+----
+{{https://remoteqth.com/img/wiki-ethernet-splitter-03.jpg}}\\
+{{ https://remoteqth.com/img/wiki-ethernet-splitter-01.jpg?100}}
+{{ https://remoteqth.com/img/wiki-ethernet-splitter-02.jpg?100}}\\
+  * For **split/join two 100 Mbit ethernet**, to one UTP wire +POE (for use need two module)
+  * **POE** terminal **transfer DC voltage** from one end to second
+  * POE limitation **MAX 24V/640mA (15W)**
+  * Both side center RJ45 **connetor LED**, show if POE is present
+  * POE voltage and polarity **protect with fitration** common mode choke on both side
+  * **ESD protection** with transient voltage suppressor
+  * Ethernet is **galvanically isolated,** with insulation 2x 1,5 kV
+  * Center single wire recomended use with **SFTP** cable (shield)
+  * Two grounding potentials **GND** and **PE (Earth)** for center line
+----
+===== Source =====
+  * [[https://remoteqth.com/hw/ethernet-splitter-01.pdf|.PDF schematics]]
+  * [[https://remoteqth.com/hw/ethernet-splitter-01-ibom.html|Interactive BOM]]
+  * [[https://remoteqth.com/hw/ethernet-splitter-01.step|.STEP 3D model]]
+  * [[https://remoteqth.com/download-count.php?Down=hw/ethernet-splitter-01.zip|.zip KiCad source code]]
+  * [[https://remoteqth.com/3d/ethernet-splitter-din-46mm.stl|.stl DIN rail mount 3D model for printer]]
+{{https://remoteqth.com/img/ethernet-splitter-01-F.png?435}}
+{{https://remoteqth.com/img/ethernet-splitter-01-B.png?400}} \\
+\\
-https://remoteqth.com/img/ethernet-splitter-01-F.png