icom-vs-3-bluetooth-headset-review
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
icom-vs-3-bluetooth-headset-review [2024/01/27 17:07] – [CW operation] ok1hra | icom-vs-3-bluetooth-headset-review [2024/01/28 18:23] (current) – [Conclusion] ok1hra | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | Icom VS-3 Bluetooth headset review | + | ====== |
+ | {{https:// | ||
- | ====== CW operation | + | ---- |
- | * The signal is **delayed by 30ms,** so it is **not possible to keying CW from the local paddle.** | + | |
+ | ===== CW operation ===== | ||
+ | * The signal is **delayed by 30ms,** so it is **not possible to keying CW from the local paddle.** | ||
+ | * The telegraph **signal rings/ | ||
+ | |||
+ | ===== SSB operation ===== | ||
+ | * Signal delay in SSB mode does not matter. **The audio accentuates the higher notes, but it's not annoying.** On the image from the oscilloscope we see a yellow signal representing the original audio from the headphone output, which slightly suppresses the higher tones. The blue waveform shows the audio from the Icom VS-3 Bluetooth module, which significantly emphasizes high notes and adds noise. \\ {{https:// | ||
+ | * It is a one-second chirp with a 6kHz lift. | ||
+ | |||
+ | ===== PTT ===== | ||
+ | * The **PTT** button is **very practical and works flawlessly.** | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | ===== Conclusion ===== | ||
+ | * The latency of the audio signal delay is a property, it is not a device error. | ||
+ | * Suppression of high frequencies would probably improve the useful properties of the device, which are good except for the CW mode. |
icom-vs-3-bluetooth-headset-review.1706375242.txt.gz · Last modified: 2024/01/27 17:07 by ok1hra