RemoteQTH

User Tools

Site Tools

Trace:
ip-switch

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
ip-switch [2020/12/28 18:16] – ok1hraip-switch [2021/05/15 20:46] (current) – ok1hra
Line 2: Line 2:
 Previous version 0.2 [[https://remoteqth.com/wiki/index.php?page=IP+Switch+with+ESP32-GATEWAY|here]] Previous version 0.2 [[https://remoteqth.com/wiki/index.php?page=IP+Switch+with+ESP32-GATEWAY|here]]
 {{https://remoteqth.com/img/slide-ip-sw-rev4-01.jpg?600}}\\ {{https://remoteqth.com/img/slide-ip-sw-rev4-01.jpg?600}}\\
 +
 ---- ----
  
Line 27: Line 28:
   - Two **jumper** for select output driver are used   - Two **jumper** for select output driver are used
   - Connector for **16 relay board** connected wth flat cable   - Connector for **16 relay board** connected wth flat cable
-  - **16 output** and common terminal **(50V/500mA MAX)** use for +  - **16 output** (50V/500mA MAX) 
-    - relay **power** if use **open colector ULN** driver +  - **COMMON** connect dependency to use driver 
-    - relay **GND** if use **open colector MIC** driver+    - if use **open colector ULN** driver, connect COMMON to relay **+DC power**  
 +    - if use **open emiter MIC** driver, connect COMMON to relay **GND** 
 ==== Sources ==== ==== Sources ====
   * [[https://remoteqth.com/hw/ip-switch-04c.pdf|.PDF schematics]]   * [[https://remoteqth.com/hw/ip-switch-04c.pdf|.PDF schematics]]
ip-switch.txt · Last modified: 2021/05/15 20:46 by ok1hra