usb_rotator_interface_4
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
usb_rotator_interface_4 [2021/11/14 15:32] – [Steps of assembly] ok1hra | usb_rotator_interface_4 [2022/02/05 18:24] – [Some tips] ok1hra | ||
---|---|---|---|
Line 85: | Line 85: | ||
The estimated difficulty of the assembly - for **moderately advanced solder maker.**\\ | The estimated difficulty of the assembly - for **moderately advanced solder maker.**\\ | ||
- Check all parts {{https:// | - Check all parts {{https:// | ||
+ | - **First time** solder three connectors **P2,P3, P4** {{https:// | ||
+ | - Connect USB cable to Rotator interface and your PC, and check (device manager in windows) **that the USB converter has been recognized correctly.** Contact us if you have any problems and do not continue assembly. {{https:// | ||
- Solder pinheader **P5, JP2, U1** and pinsocket 6x2 **P3** \\ **WARNING, do not solder P1!**\\ | - Solder pinheader **P5, JP2, U1** and pinsocket 6x2 **P3** \\ **WARNING, do not solder P1!**\\ | ||
- Solder **S4** reset switch {{https:// | - Solder **S4** reset switch {{https:// | ||
Line 92: | Line 94: | ||
- Put 3D print **LCD frame** {{https:// | - Put 3D print **LCD frame** {{https:// | ||
- Remove protective foil from LCD {{https:// | - Remove protective foil from LCD {{https:// | ||
- | - Put on LCD to pinheader and **screw the M3x10 into the corner** of the plastic frame (without the use of a nut, the hole is conical) {{https:// | + | - Put on LCD to pinheader and **screw the M3x10 into the corner** of the plastic frame (without the use of a nut, the hole is conical) {{https:// |
- During solder LCD **press the frame and the LCD** so that there is no space between them {{https:// | - During solder LCD **press the frame and the LCD** so that there is no space between them {{https:// | ||
- Solder all 16 pins {{https:// | - Solder all 16 pins {{https:// | ||
Line 335: | Line 337: | ||
- [[https:// | - [[https:// | ||
- And [[https:// | - And [[https:// | ||
+ | - If do not show degree character (°), change in file rotator_settings.h settings to< | ||
==== TODO ==== | ==== TODO ==== | ||
* component BOM | * component BOM |
usb_rotator_interface_4.txt · Last modified: 2022/02/17 22:23 by ok1hra