Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| usb_rotator_interface_4 [2022/02/05 18:22] – [Some tips] ok1hra | usb_rotator_interface_4 [2022/02/17 22:23] (current) – [Connect Azimuth cw/ccw pulse] ok1hra |
|---|
| - **P5 jumper switch to enable.** | - **P5 jumper switch to enable.** |
| - Input must grounded to **digital GND**. | - Input must grounded to **digital GND**. |
| - Next step test with [[usb_rotator_interface_4#install_test_firmware|test firmware]].\\ | - Next step test with [[usb_rotator_interface_4#install_test_firmware|test firmware]]. |
| | - Note: [[https://remoteqth.com/w/doku.php?id=usb_rotator_interface_4#firmware|K3NG firmware]] use only pin12. \\ |
| |
| ---- | ---- |
| - [[https://github.com/ok1hra/k3ng_rotator_controller/blob/master/k3ng_rotator_controller/rotator_language.h#L22|Azimuth shorts]] you can replace with prefixes which are in the same direction from your QTH. For example see [[https://github.com/ok1hra/k3ng_rotator_controller/blob/master/k3ng_rotator_controller/rotator_language.h#L126|prefixes from OK]]. | - [[https://github.com/ok1hra/k3ng_rotator_controller/blob/master/k3ng_rotator_controller/rotator_language.h#L22|Azimuth shorts]] you can replace with prefixes which are in the same direction from your QTH. For example see [[https://github.com/ok1hra/k3ng_rotator_controller/blob/master/k3ng_rotator_controller/rotator_language.h#L126|prefixes from OK]]. |
| - And [[https://github.com/ok1hra/k3ng_rotator_controller/blob/master/k3ng_rotator_controller/rotator_language.h#L13|Azimuth]] you can replace with **name your antenna or tower**, e.g. //20m YAGI//. | - And [[https://github.com/ok1hra/k3ng_rotator_controller/blob/master/k3ng_rotator_controller/rotator_language.h#L13|Azimuth]] you can replace with **name your antenna or tower**, e.g. //20m YAGI//. |
| - If do not show degree character (°), change in file rotator_settings.h settings to<code>#define DISPLAY_DEGREES_STRING "\xB2"</code> \\ | - If do not show degree character (°), change in file rotator_settings.h settings to<code>#define DISPLAY_DEGREES_STRING "\xB2"</code> If the LCD displays instead of the character degree (°) lower case **"alpha" (α),** find in source code all string **'char(223)'** and replace to **'char(178)'**. |
| If the LCD displays instead of the character degree (°) lower case "alpha" (α), find in source code all string 'char(223)' and replace to 'char(178)'.'' | |
| ==== TODO ==== | ==== TODO ==== |
| * component BOM | * component BOM |
