Main page
Recent changes
Rotator module version 3.3
B
I
U
S
link
image
code
list
Show page
Syntax
! Connection examples * [Bypass original controller G450] !!Use with original control box * [OH3BHX firmware for G400RC|https://github.com/mikaelnousiainen/k3ng_rotator_controller/commit/037f54114cae951ed711b09a7eff2f339c1fe19e] and [connection|https://remoteqth.com/img/rot3_G-400_by_OH3BHX.jpg] * [Yaesu G-5400B] * [Yaesu G-2800DXA] * [DF2LH solution with Kenpro G800-1000SDX|https://remoteqth.com/img/wiki-df2lh-kenpro-g800-1000sdx-v1.3.gif] * [Yaesu G800|https://remoteqth.com/img/wiki-yaesu-g800.png]{{pin DB15 G800 unit ------------------------- 1+2 -> 5 3+4 -> 4 15 -> 1 14 -> 2 GND -> 3}} !!CDE/HyGain HAM IV (grounded center potentiometer) * [Resolving without compromise|Solutions for HAM IV rotator - remove ground center and connect new wire] - mechanically remove grounded center and connect by [three wire|https://remoteqth.com/img/wiki-ac2-rotator.svg] * [Solutions by VA2NA|Solutions for HAM IV rotator by VA2NA] - external add-on * [Solutions by DM2RM|Solutions for HAM IV rotator by DM2RM] - external add-on * [Add resistor|https://remoteqth.com/img/wiki-ac-rotator.svg] with grounded two wire potentiometer - this solutions produce '''nonlinearity voltage.''' You can use [calibration table|https://github.com/k3ng/k3ng_rotator_controller/wiki/500-Heading-Calibration] - is not recommended. !!Ten turn azimuth potentiometer (one turn used) * Need negative and positive voltage source * Set potentiometer bridge from 0 to +5V output **'''Left''' trimmer set a '''0V''' after full '''CCW''' rotate **by '''right''' trimmer, set the '''+5V''' after full '''CW''' rotate **Repeat until the voltage agree * [Circuit|https://remoteqth.com/img/wiki-rotator-bridge.svg]
Password
Summary of changes