Rotators

<<- RemoteQTH-server

RemoteQTH server supports only the controll arduino opensource rotator interface/controller by K3NG (Asembly Manual).

What you need(Edit)

  • USB/UART converter
  • Arduino rotator contoller

Rotators page setting up to 8 Arduino rotators controller connect to server via USB/UART interface.

Every interface must have a different serial number, to uniquely identify the server!

After set this form you can repluged your usb device or reboot server, for detection new USB rotator interface.

Configure Rotators(Edit)

You can enable up to eight rotators, or disable.

  • Name: for rotator can have maximum 25 characters (not required). If set name as n/a, this rotator is not shown in control section.
  • USB Vendor id: must have at 4 characters.
  • USB Product id:must have at 4 characters.
  • USB sn: must have at least 1 characters, and maximum 20 characters.
  • From Azimuth: must be number 0-450
  • To Azimuth: must be number 0-450
  • Custom GET command: available command send to rotator for get azimuth
    • default for K3NG arduino control 'C\r'
  • Custom SET command: available command send to rotator for set azimuth
    • default for K3NG arduino control 'C\rM#\r'
    • Command format

For finding id's and serial numbers USB device you can use a pop-up window on top of page. This window print dmesg message from kernel of system, After plug usb device you see

Every rotator also listen to an unique IP port: Rot1-8 is responsible port 91-98.

Configure Azimuth map(Edit)

  • Your locator: locator format must be six characters in format XX##XX
    • XX The first pair (a field) encodes with the letters "A" to "R".
    • ## The second pair (square) encodes with the digits "0" to "9".
    • XX The third pair (subsquare) encodes with the letters "A" to "X".

Your Locator you can find here 1, 2, 3

New map can be generated for longer than ten seconds. Wait, eventually refresh this page.

jo70va dm99aa
qf56ob pm95vq