3D printed shield, against overheating of the thermometer in direct sunlight.
The doubling of the shield makes it possible to better shield the salve heat from the heated outer shield.

Source files on GitHub

• I include the source file sun-shield.scad in OpenScad
• exported .STL files for individual parts (preset for mounting rods with a diameter of 42 mm)
• preset .3mf files

	Allen key 2,5mm
	Soldering station

—-

1. First step measure mouting pipe diameter
2. Open source code in OpenScad and change line

   MOUNTDIA  =  42;

3. Change the parameter gradually from 1 to 3

   Part  =  1;

   then press F6 and F7 for .STL export this part. Other parts not depend to mounting pipe diameter.

4. After complete all STL parts you can start 3D printing with WHITE PETG filament. Sun-shield part nr 4 you print four times.

1. Take part number one, half part number two on it and screw three M3 screws.
   ATTENTION, keep in mind that you are working in plastic and you cannot use great force for tightening.
   
   
2. Attach the thermistor to the center of the 3D printed part number 3 with the binding tape
   
   
3. Thread the thermistor cable through the eye in the 3d printed part number 2, as in the picture.
   
   
4. Screw parts two and three together using three M3 screws so that the cable exits through the gap as shown in the picture.
   
   
5. Attach the cable to part 3 with a cable tie
   
   
6. Screw together all four 3d printed parts number 4, using twelve M3 screws
   
   
7. Finally, close by screwing the 3D printed part number 5
   
   
8. Attach the assembled shield to the mounting pipe using two plastic binding strips
   
   

3D print WX station Wiki

1. Unscrew the brass nut, remove the grille and unscrew the second brass nut below it.
   
   
2. Remove the printed part number 2 from the weather station and pass the cable from the thermistor through the grille and the removed part. Putting on the grid during stretching will make it easier for you to orientate it. Pay attention to the direction of the cable, soldered ends inwards/upwards.
   
   
3. Solder the end of the cable to the PCB as shown in the picture
   
   
4. Put the plastic parts back on the weather station and screw with the brass nut.
   
   
5. Put the grill back on, screw it with a brass nut and fasten the free cable to the threaded rod with a plastic tie.