Small 2-way RX splitter / combiner in aluminium enclosure OK2ZAW

The splitter or combiner is a very useful device. It can provide equal voltages, equal current, or equal power to matched or unmatched loads. Like all passive splitters and combiners, this device is less than ideal. Isolation is maximum only when at least one port are properly terminated. In this case isolation between the two splitted/combinated ports is maximum when the main port is properly terminated. This HW is designed only for RX line. There are some more high current and voltage protections on all ports. Both impedances 50 or 75 Ohm can be selected by the jumper.

Main functions:

• Info:
  • Broadband: 0.1 MHz to 60 MHz
  • Splitter or Combiner
  • Low loss
  • Protections- high voltage / current
  • 50/75 ohm impedance - easy jumper switch
• Electrostatic protection with glim lamps.
• High power protection.
• Quality SMA connectors.
• Aluminium enclosure size W x H x L = 58 x 24 x 50.
• Available as
  • KIT : all parts + PCB
  • Assembled : ready to use

Parameters:

• Info:
  • Impedance 50 or 75 Ohm
  • Insert loss: around 0,5 dB
  • Split 3 dB, together with IL around 3,5 dB
  • Isolation more than 30 dB, 160-15 m more than 40 dB
  • SWR on splitted ports better than 1:1,1 on HF, resp. 1:1,19 on 6 m
  • SWR on main port around 1:1,3 on HF, resp. 1:1,4 on 6 m
  • Maximal current continue 100 mA
  • Maximal voltage around 65 V

Use:

• Antennas splitter
• RX signal divider
• One antenna, two RX

Versions:

• KIT or assembled

The measured values

Isolation and SWR on splitted ports

SWR on main port and Insert loss

Download

2-way splitter
Schematic and board pic	sch	brd
Source files		KiCAD249
We believe open source is a better way of doing things. View and download the Shield Schematic and PCB files. The hardware designs are released under the Attribution-NonCommercial 2.0 Generic